Tech Inspection

Vehicle Safety & Tech Inspection

Members participating in their first PDC hosted event of the season will be required to have their vehicle inpsected according to PDC's Vehicle Safety Inspection Guidelines conducted by any registered workshop or dealer.

Inspection is valid up until the end of each season.

Vehicle Inspection Form (20KB PDF)

Completed inspection forms must be presented on arrival at the track. In all cases, members are responsible for the condition and safe operation of their vehicle.

New vehicles less than 6 months old with less than 5,000 km are exempt from the vehicle inspection.

An on-track Tech Inspection will be conducted on the day of the event. Failure to meet the requirements will result in exclusion from the event.

On-Track Tech Inspection

On-track tech Inspection will be conducted at all PDC hosted events. Failure to pass the inspection will result in exclusion from the event.


1. Brakes - minimum 50% brake lining on pads.
2. Brake Fluid - must be clean and full.
3. Tires - DOT approved, 3/32" min tread depth, not below wear bar, no cuts or cracks and no repairs to sidewalls.
4. Wheel nuts - properly torque according to manufacturer's specs.
5. Fuel cap must be securely fastened and leak free.
6. Hood and deck lids must be securely fastened.
7. Headlights and Brake Lights operating properly.
8. Windshield - no cracks longer than four inches.
9. Safety Belts - in good operating condition.
10. Batteries - securely fastened with no visible leaks or corrosion.
11. Throttle - smooth uninterrupted release.
12. Helmet - Snell (automotive) rating according to current regulations.
13. Driver Safety Gear - in accordance with Run Group requirement.
14. All loose items (inside passenger, luggage, glove and engine compartments) must be removed from the car.
15. Car ID number decals - displayed clearly.
    
16. Exhaust - must not exced 90dB at 60 feet as measured by Track Manager.